Bolting Table Saw To The Floor - Craftsman 152.221040 Owner's Manual

2. Open motor cover, plug switch cord (C) into motor BOLTING TABLE SAW TO THE FLOOR
cord (D). See figure 12-2.
Fig. 12-2
MAKE CERTAIN the table saw is disconnected from
the power source.
If you wish, the table saw can be permanently mounted
to the floor. To attach to the floor, see instructions
below.
Fig. 12A-1
B
3.
4.
Pull slack in switch cord into the cabinet.
Make a loop (E) from the slack of the switch cord
and place it behind cord retaining bar (F).
See figure 12-2.
B
A
1.
2.
3.
4.
5.
Remove the four rubber footpads (A) from the table
saw legs (B). See Figure 12A-1.
Position the table saw where you want it perma-
nently mounted.
Mark the floor through the holes in the bottom of
legs.
Move the table saw out of the way and drill pilot
holes at the four locations marked.
Attach the table saw to the floor using appropriate
hardware (not included).
22