Unpacking - Craftsman 17540 - 9.5 Amp 1-3/4 HP Plunge Base Router Operator's Manual

ADDITIONAL RULES FOR SAFE OPERATION cent.
7. ALWAYS check the tool for damaged perta, Before ludhsr use of thetoo!, a guard or
other part that Is damaged should be carefullychecked todetermine ff It will operate
propedyand performIts Intended funstlon. Check for mlsallgnment or bindingof
moving parts, breakage of paris, and any other conditionthat may affect the tool's
opera!Ion.A guard or other pert that la damaged should be properlyrepaired or roptacad
at e Sears Service Cente_
8. INSPECT and remove all nails from lumber before routing.
g. SAVE THESE INSTRUCTIONS. Refer to them frequently and use them to Instruct
others who may use thls tool. If someone borrows this toot, make ours they have
these Instructions also=
Z_ WARNING: Your rreuter should NEVER be connected to the power source
when you are asssmb!lng parts, maldng adjustments, Installing or removing
collate / nuts, cutter bits, cleaning or when It Is not In use, Dfsconnsctlng the
muter will prevent accidental starting, which could cause serious personal
Injury,
When unpacking the box don't discard any packingmaterials unltt all of the contents are
accountedfor:.
1. Carefully lift the Router Motor and Plunge Base with the li2-1n, collar/nut already
Installed, out of the cartonend place on a stable flat surfase.
2 Open the parts bag to locate the following:
• Sawdust Extraction Hood and 2 Screws usedto attachhood to base
• 1/4-in. Col!st/Nut
• Conet/Nut wrench
& Inspect the Items carefutFy to make sure that no breakage or damage has occurred
during ahlpplng If any of the llama mentioned are missing, (refer to "PARTS LIST"
IlIuslratlon on page 11), return the router to your nearest Sears store or Craftsman
outlet to have the muter replaced.
z_ WARNING: If any parts are broken or mlselng, DO NOT attempt to plug
In the power cord or operate muter until the broken or missing parts are
repfaced_Failure to do so could result In possible serious Injury.
10