Craftsman 11585 - C3 19.2 Volt 7-1/4 in. Circular Saw Operator's Manual page 16

USING THE LASER GUIDES
See Figures 12- 13.
'_ WARNING: Do not stare into the laser beams or
turn the lasers on when the tool is not in use. Failure
to heed this warning could result in possible serious
personal injury.
The laser guides will generate a red colored laser beam
on the work surface in front of and behind the saw when
turned on. The front laser aids in following the line of cut
when cutting the workpiece. The rear laser aids in align-
ing pocket cuts and following the kerf when exiting the
workpiece.
NOTE: The laser units come from the factory already
installed and aligned. If the lasers become misaligned
after time, refer to the "Adjustments" section later in this
manual.
NOTE: Make a trial cut on a piece of scrap material
to ensure laser is aligned; adjusting the laser may be
necessary.
[] Mark the line to be cut on the workpiece.
[] Adjust the depth and angle of the cut as needed.
[] Insert battery pack into saw and press the laser guide
button to activate the laser.
[] Start the motor.
NOTE: Do not touch the blade to the workpiece until
the saw has reached maximum speed.
[] Slowly push the saw forward into the workpiece.
NOTE: Keep the laser beam on the marked line on the
workpiece for precision cutting.
[] Once the cut is complete, allow the saw to come to a
complete stop before turning off the laser.
[] Remove battery pack from saw.
\
LASERGUIDE
SWITCH
Fig. 12
Fig. 13
16