General Safety Rules; Operation - Craftsman 11585 - C3 19.2 Volt 7-1/4 in. Circular Saw Operator's Manual

A
WARNING: Do not allow familiarity with tools to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
A
WARNING: Always wear safety goggles or safety
glasses with side shields when operating tools.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
A
WARNING: Do not use any attachments or acces-
sories not recommended by the manufacturer of
this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
[] Cutting all types of wood products (lumber, plywood,
paneling)
[] Cross Cutting/Rip Cutting
[] Bevel Cutting
[] Pocket Cutting
This product will accept DieHarde_ 19.2 V lithium-ion bat-
tery packs and Craftsman 19.2 V nickel-cadmium battery
packs.
For complete charging instructions, refer to the Operator's
Manual for the battery packs and chargers listed in the
General Safety Rules.
BATTERY PROTECTION FEATURES
DieHardo 19.2 V lithium-ion battery packs are designed
with features that protect the lithium-ion cells and
maximize battery life.
If the tool stops during use, release the trigger to reset
and resume operation. If the tool still does not work, the
battery needs to be recharged.
TO INSTALL BATTERY PACK
See Figure 4.
[] Place the battery pack in the saw. Align the raised rib
on the battery pack with the groove inside the saw,
then slide the battery pack into the saw.
[] Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
saw before beginning operation.
DEPRESS LATCHES TO
RELEASE BATTERY PACK
®
BATTERYPACK
LATCHES
Fig. 4
A
CAUTION: When placing battery pack in the tool,
be sure raised rib on battery pack aligns with the
back of the saw and latches into place properly.
Improper installation of the battery pack can cause
damage to internal components.
WARNING: Always remove battery pack from your
tool when you are assembling parts, making adjust-
ments, cleaning, or when not in use. Removing bat-
tery pack will prevent accidental starting that could
cause serious personal injury.
TO REMOVE BATTERY PACK
See Figure 4.
[] Locate the latches on side of battery pack and depress
to release the battery pack from the saw.
[] Remove the battery pack.
12