Craftsman 11585 - C3 19.2 Volt 7-1/4 in. Circular Saw Operator's Manual page 13

A
WARN(NG: Battery tools are always in operating
condition. Therefore, switch should always be locked
when not in use or carrying at your side.
KICKBACK
See Figures 5 - 8.
Kickback occurs when the blade stalls rapidly and the
saw is driven back toward you. Blade stalling is caused by
any action which pinches the blade in the wood.
DANGER: Release switch immediately if blade
binds or saw stalls. Kickback could cause you to
lose control of the saw. Loss of control can lead to
serious injury.
To guard against kickback, avoid dangerous practices
such as the following:
[] Setting blade depth incorrectly
[] Sawing into knots or nails in workpiece
[] Twisting the blade while making a cut
[] Making a cut with a dull, gummed up, or improperly set
blade
[] Supporting the workpiece incorrectly
[] Forcing a cut
[] Cutting warped or wet lumber
[] Operating the tool incorrectly or misusing the tool
To lessen the chance of kickback, follow these safety
practices:
[] Keep blade at the correct depth setting. The depth set-
ting should not exceed 1/4 in. below the material being
cut.
[] Inspect the workpiece for knots or nails before cutting.
Never saw into a knot or nail.
[] Make straight cuts. Always use a straight edge guide
when rip cutting. This helps prevent twisting the blade.
[] Use clean, sharp, and properly set blades. Never make
cuts with dull blades.
[] Support the workpiece properly before beginning a cut.
[] Use steady, even pressure when making a cut. Never
force a cut.
[] Do not cut warped or wet lumber.
[] Hold the saw firmly with both hands and keep your
body in a balanced position to resist the forces if kick-
back should occur.
A
WARNING: When using the saw, always stay alert
and exercise control. Do not remove the saw from
the workpiece while the blade is moving.
13
KICKBACK-BLADESETTOODEEP
)
Fig. 5
Fig. 6
J
CORRECT BLADEDEPTH= BLADEEXPOSED1/4 in. ORLESS
ON UNDERSIDE OFWORKPIECE
Fig. 7
CORRECT SUPPORT
Fig. 8