Setting The Blade Depth - Craftsman 11585 - C3 19.2 Volt 7-1/4 in. Circular Saw Operator's Manual

d_, WARNING: A lwaysremove thebattery packfrom
TO
TIGHTEN
the tool when changing operation settings or when
the tool is not in use. Failure to remove the battery
pack may result in accidental starting and serious
personal injury.
SETTING THE BLADE DEPTH
See Figure 11.
Always keep the correct blade depth setting. The correct
blade depth setting for all cuts should not exceed 1/4 in.
below the material being cut. More blade depth will
increase the chance of kickback and cause the cut to be
rough. For more depth of cut accuracy, a scale is located
on the upper blade guard.
[] Remove the battery pack from the saw.
[] Loosen the depth adjustment knob.
[] Determine the desired depth of cut.
[] Locate the depth of cut scale on the back of the upper
blade guard.
[] Hold the base flat against the workpiece and raise or
lower the saw until the indicator mark on the bracket
aligns with the desired scale measurement on the
blade guard.
[] Tighten the depth adjustment knob securely.
TO
LOWERSAW
DEPTH
ADJUSTMENT
KNOB
TO
LOOSEN
BASE
ASSEMBLY
Fig. 11
15