Subscribe to Our Youtube Channel
Related Manuals for ZKTeco TS2200 Pro Series
Summary of Contents for ZKTeco TS2200 Pro Series
- Page 1 Installation Guide TS2200 Pro Series Tripod Turnstile Version: 1.0 Due to regular upgrades of systems and products, ZKTeco could not guarantee exact consistency between the actual product and the written information in this manual.
-
Page 2: Installation Requirements
1 Installation Requirements It is recommended that the tripod turnstile must be installed on a horizontal solid platform with a height of 50mm to 100mm. It is also recommended that the tripod turnstile should not be used in the corrosive environment. Make sure that the ground wire of the system is securely connected to avoid personal injuries or other accidents. -
Page 3: Installation
3 Preparation The following items are required before installing the TS2200 Pro: A Screwdriver: To remove or install the screw on the device. A Pencil: To mark the device size and the screw hole. A Electric Drill: To drill holes in accordance to the marked screw holes. A Wrench: To secure the M12 expansion screw on the device. - Page 4 Open the chassis of the turnstile with the key and remove the chassis covers. ① ② Remove the screws and the chassis covers. ② ①...
- Page 5 Use a pencil to mark the holes on the turnstile. 1120mm 303mm 303mm ① Wire Hole X2 (φ60mm) Screw Hole X6 L＞60mm W≤60mm ② Conduit Conduit Conduit Conduit...
- Page 6 Remove the turnstile and use an electric drill to drill holes according to the markings. Screw Hole Concrete ① ② According to the wire hole, a cutting machine makes two conduit that is 30mm wide and 60mm deep.
- Page 7 Clean up the debris and dust after drilling, and then place the turnstile on the installation site again. Check whether the drilled holes are align with the mark on the turnstile. ① ②...
- Page 8 Put φ20mm PVC pipes , and insert Ethernet and Power cables through the pipes lines, and then pour the concrete to the fill the slot. ② Ethernet ① ③ Pour Concrete...
- Page 9 Ethernet Power Cable 20mmPVCpipe 20mmPVCpipe Align the device with the drilled holes. Then, insert the bolts accordingly and fix them with a wrench. Finally, insert the washers and the nuts, then tighten it with a wrench. Washer Mounting Bolt Washer Bracket Bolt Concrete...
- Page 10 Install the chassis covers with the screws. ① ② Install the chassis covers and use the key to lock it. ② ①...
- Page 11 Use the key to open the top lid of the turnstile. ② ① Align the arm assembly with the internal chassis assembly , and then secure it with the screws.
- Page 12 After assembling the arm, the resistance of the arm can be adjusted by rotating the damper left and right. Rotate the damper and observe the number on the damper. The resistance will increase as the number increases. Damper...
- Page 13 Close the top lid and lock i ① ② We suggest marking a warning line on the floor to remind the user, when installation is completed. It reminds the user to wait outside the warning line until the previous user completed the verification process and passed through the turnstile...
-
Page 14: Wiring Diagram
5 Wiring Diagram... - Page 15 ZKTeco Industrial Park, No. 32, Industrial Road, Tangxia Town, Dongguan, China. Phone : +86 769 - 82109991 : +86 755 - 89602394 www.zkteco.com Copyright © 2023 ZKTECO CO., LTD. All Rights Reserved.
Need help?
Do you have a question about the TS2200 Pro Series and is the answer not in the manual?
Questions and answers