ZKTeco TS 1000 Pro Series Installation Manual
  1. Manuals
  2. Brands
  3. ZKTeco Manuals
  4. Turnstiles
  5. TS1000 Pro Series
  6. Installation manual

ZKTeco TS 1000 Pro Series Installation Manual

Tripod turnstile
Hide thumbs Also See for TS 1000 Pro Series:
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
Installation Guide
Applicable Models: TS 1000/2000 Pro series
Tripod Turnstile
Version: 1.1
Due to regular upgrades of systems and products, ZKTeco could not guarantee exact consistency between the
actual product and the written information in this manual.

Advertisement

Table of Contents
loading

Related Manuals for ZKTeco TS 1000 Pro Series

Summary of Contents for ZKTeco TS 1000 Pro Series

  • Page 1 Installation Guide Applicable Models: TS 1000/2000 Pro series Tripod Turnstile Version: 1.1 Due to regular upgrades of systems and products, ZKTeco could not guarantee exact consistency between the actual product and the written information in this manual.

  • Page 2: Installation Conditions

    1 Installation 1.1 Installation Conditions When installing the tripod turnstile against the wall, please reserve at least 100 mm space for opening the cover. As shown in Figure 1-1. Figure 1-1 1.2 Cabling Power supply and communication wire suggested to deployed underground then into the cabinet of device.

  • Page 3: Installation Notes

    2 Installation Notes In order to keep the arm won't be damaged during the transportation. The arm wasn't install on device. Put arm kit into the hole of cabinet, make sure the screw holes match with mechanism core, then tighten 3 hex screws, as shown in Figure 2-1. Figure 2-1 Please make sure that the power requirements are strictly met to avoid permanent damage to the unit.
  • Page 4 3 Control Board Introduction 3.1 Function Description of the Turnstile Control Board If you are using standard device that without RFID or Fingerprint reader, you need to connect access control system to the main board, please check the content in this chapter carefully. Turnstile control board's diagram as shown in Figure3-1.
  • Page 5 Figure3-1 Note: The third party access control system lock relay trigger time should be 1 second or less than 1 second. 3.2 Connection Diagram of the Access Controller Note: The lock relay duration of access controller device needs to be set to 1s. Forbidden using electrically charged objects to connect to the port of Opening Signal Input, otherwise will damage the control board.

  • Page 6: Maintenance

    4 Maintenance Forming maintenance consciousness The tripod turnstile needs to be maintained regularly and repaired once it is damaged. It is recommended that warning signs being placed at conspicuous positions for prompting passers-by to pass in a proper way and in good order. Reasonable maintenance consciousness helps to guarantee long-term usage of the tripod turnstile.

  • Page 7: Troubleshooting

    5 Troubleshooting Symptom Troubleshooting It may be caused by the power supply or circuit. The indicator is not lighted when the Check whether the connection cable and power cable equipment is powered on. between are damaged, or the wiring is loose. It may be caused by the problem of relative components The arms of the tripod turnstile or drop-arm solenoid.
  • Page 8 ZKTeco Industrial Park, No. 32, Industrial Road, Tangxia Town, Dongguan, China. Phone : +86 769 - 82109991 : +86 755 - 89602394 www.zkteco.com Copyright 2021 ZKTECO CO., LTD. All Rights Reserved.

This manual is also suitable for:

Ts 2000 pro series

Table of Contents