ZKTeco TS1000 Pro Series Installation Manual
Tripod turnstile
Hide thumbs
Also See for TS1000 Pro Series:
- User manual (18 pages) ,
- Installation manual (8 pages) ,
- User manual (16 pages)
Related Manuals for ZKTeco TS1000 Pro Series
Summary of Contents for ZKTeco TS1000 Pro Series
- Page 1 Installation Guide TS1000/2000 Pro series tripod turnstile Version: 1.0 Date: September 2018 1 F16 Quick Start Guide...
-
Page 2: Chapter 1 Installation
Chapter 1 Installation 1.1 Installation conditions When installing the tripod turnstile against the wall, please reserve at least 100 mm space for opening the cover. As shown in Figure 1-1. Figure 1-1 1.2 Cabling Power supply and communication wire are suggested to deploy underground then into the cabinet of device. 1.3 Drilling holes Drill holes according to the locations of the screw holes. -
Page 3: Chapter 2 Installation Notes
Chapter 2 Installation Notes In order to prevent the arm from damaging during transportation, the arm will not be initially installed to the devices. Put the arm into the hole of cabinet; make sure the screw holes match with mechanism core, then tighten 3 hex screws, as shown in Figure 2-1. -
Page 4: Chapter 3 Control Board Introduction
Chapter 3 Control Board Introduction 3.1 Function description of the turnstile control board If you are using a standard device without an RFID or fingerprint reader, you need to connect an access control system to the main board; please check the content in this chapter carefully. Turnstile control board’s diagram as shown in Figure3-1 Figure 3-1 Note: The third-party access control system’s lock-relay-trigger-time should be 1 second or less than 1 second. - Page 5 3.2 Connection diagram of the access controller Note: The lock relay duration of an access controller device needs to be set to 1s. Do not use electrically charged objects to connect to the port of Opening signal input, otherwise it will damage the control board.
-
Page 6: Chapter 4 Maintenance
Chapter 4 Maintenance Forming maintenance consciousness The tripod turnstile needs to be maintained regularly and repaired once it is damaged. It is recommended placing warning signs at conspicuous positions for alerting every passersby to pass carefully and in good order. Reasonable maintenance consciousness helps to guarantee long-term usage of the tripod turnstile. -
Page 7: Chapter 5 Troubleshooting
Chapter 5 Troubleshooting Symptom Troubleshooting It may be caused by the power supply or circuit. The indicator is not lighted when Check whether the connection cable and power cable are the equipment is powered on. damaged, or whether the wiring is loosed. It may be caused by the problem of related components or drop- The arms of the tripod turnstile arm solenoid.