Port Setup; Figure 28 Basic Setting > Port Setup; Table 12 Basic Setting > Port Setup - ZyXEL Communications Dimension ES-2048 User Manual

Chapter 7 Basic Setting
Table 11 Basic Setting > IP Setup (continued)
LABEL
Index
IP Address
IP Subnet Mask
VID
Default Gateway
Manageable
Delete
Cancel

7.7 Port Setup

Use this screen to configure Switch port settings.Click Basic Setting > Port Setup in the
navigation panel to display the configuration screen.
Figure 28 Basic Setting > Port Setup
The following table describes the labels in this screen.
Table 12 Basic Setting > Port Setup
LABEL
Port
*
Active
76
DESCRIPTION
This field displays the index number of the rule. Click an index number to edit
the rule.
This field displays the IP address.
This field displays the subnet mask.
This field displays the ID number of the VLAN group.
This field displays the IP address of the default gateway.
This field displays whether the Switch can be managed using the IP address.
Check the management IP addresses that you want to remove in the Delete
column, then click the Delete button.
Click Cancel to clear the selected checkboxes in the Delete column.
DESCRIPTION
This is the port index number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select this check box to enable a port. The factory default for all ports is enabled. A
port must be enabled for data transmission to occur.
ES-2048 User's Guide