Mounting The Switch On A Rack; Figure 6 Attaching The Mounting Brackets; Figure 7 Mounting The Switch On A Rack - ZyXEL Communications Dimension ES-2048 User Manual
Layer 2 ethernet swicth
Hide thumbs
Also See for Dimension ES-2048:
- User manual (311 pages) ,
- Release note (4 pages) ,
- Declaration of conformity (1 page)
Table of Contents
Advertisement
Figure 6 Attaching the Mounting Brackets
2 Using a #2 Philips screwdriver, install the M3 flat head screws through the mounting
bracket holes into the switch.
3 Repeat steps
switch.
4 You may now mount the switch on a rack. Proceed to the next section.
2.2.3 Mounting the Switch on a Rack
1 Position a mounting bracket (that is already attached to the switch) on one side of the
rack, lining up the two screw holes on the bracket with the screw holes on the side of the
rack.
Figure 7 Mounting the Switch on a Rack
2 Using a #2 Philips screwdriver, install the M5 flat head screws through the mounting
bracket holes into the rack.
3 Repeat steps
ES-2048 User's Guide
1
and
2
to install the second mounting bracket on the other side of the
1
and
2
to attach the second mounting bracket on the other side of the rack.
Chapter 2 Hardware Installation and Connection
39
Advertisement
Table of Contents
Troubleshooting
