ZyXEL Communications Dimension ES-2048 User Manual page 75

Table 11 Basic Setting > IP Setup (continued)
LABEL
DHCP Client
Static IP Address
IP Address
IP Subnet Mask
Default Gateway
VID
Out-of-band Management IP Address
IP Address
Subnet Mask
Default Gateway
Apply
Cancel
In-band IP Addresses
You can create up to 63 IP addresses, which are used to access and manage the Switch from the ports
belonging to the pre-defined VLAN(s). You must configure a VLAN first.
IP Address
IP Subnet Mask
VID
Default Gateway
Manageable
Add
Cancel
ES-2048 User's Guide
DESCRIPTION
Select this option if you have a DHCP server that can assign the Switch an IP
address, subnet mask, a default gateway IP address and a domain name server
IP address automatically.
Select this option if you don't have a DHCP server or if you wish to assign static
IP address information to the Switch. You need to fill in the following fields when
you select this option.
Enter the IP address of your Switch in dotted decimal notation for example
192.168.1.1.
Enter the IP subnet mask of your Switch in dotted decimal notation for example
255.255.255.0.
Enter the IP address of the default outgoing gateway in dotted decimal notation,
for example 192.168.1.254.
Enter the VLAN identification number associated with the Switch IP address.
This is the VLAN ID of the CPU and is used for management only. The default is
"1". All ports, by default, are fixed members of this "management VLAN" in order
to manage the device from any port. If a port is not a member of this VLAN, then
users on that port cannot access the device. To access the Switch make sure
the port that you are connected to is a member of Management VLAN.
Enter the IP address of your Switch in dotted decimal notation for example
192.168.0.1.
If you change this IP address, make sure the computer connected to this
management port is in the same subnet before accessing the Switch.
Enter the IP subnet mask of your Switch in dotted decimal notation for example
255.255.255.0.
Enter the IP address of the default outgoing gateway in dotted decimal notation,
for example 192.168.0.254.
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Click Cancel to begin configuring the fields again.
Enter the IP address for managing the Switch by the members of the VLAN
specified in the VID field below.
Enter the IP subnet mask in dotted decimal notation.
Type the VLAN group identification number.
Enter the IP address of the default outgoing gateway in dotted decimal notation.
Select this option to allow the Switch to be managed via HTTP, Telnet or SNMP
using this specified IP address.
When this option is not selected the Switch still responds to ICMP requests.
Click Add to insert the entry to the summary table below and save your changes
to the Switch's run-time memory. The Switch loses these changes if it is turned
off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields to your previous configuration.
Chapter 7 Basic Setting
75