Spanning Tree Configuration; Figure 48 Advanced Application > Spanning Tree Protocol; Figure 49 Advanced Application > Spanning Tree Protocol > Configuration; Table 25 Advanced Application > Spanning Tree Protocol > Configuration - ZyXEL Communications Dimension ES-2048 User Manual

Chapter 11 Spanning Tree Protocol
Figure 48 Advanced Application > Spanning Tree Protocol
This screen differs depending on which STP mode (RSTP or MSTP) you configure on the
Switch. This screen is described in detail in the section that follows the configuration section
for each STP mode. Click Configuration to activate one of the STP standards on the Switch.

11.3 Spanning Tree Configuration

Use the Spanning Tree Configuration screen to activate one of the STP modes on the
Switch. Click Configuration in the Advanced Application > Spanning Tree Protocol.
Figure 49 Advanced Application > Spanning Tree Protocol > Configuration
The following table describes the labels in this screen.
Table 25 Advanced Application > Spanning Tree Protocol > Configuration
LABEL
Spanning Tree
Mode
Apply
Cancel
106
DESCRIPTION
You can activate one of the STP modes on the Switch.
Select Rapid Spanning Tree or Multiple Spanning Tree. See
page 101 for background information on STP.
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Click Cancel to begin configuring this screen afresh.
Section 11.1 on
ES-2048 User's Guide