Console Port; Ethernet Ports; Table 1 Panel Connections - ZyXEL Communications Dimension ES-2048 User Manual

Chapter 3 Hardware Overview
The following table describes the ports on the panels.

Table 1 Panel Connections

CONNECTOR
48 10/100
Mbps RJ-45

Ethernet Ports

Two Dual
Personality
Interfaces
2 100/1000
Mbps RJ-
45 Gigabit
Ports
2 Mini-
GBIC Ports

Console Port

Management
Port
3.1.1 Console Port
For local management, you can use a computer with terminal emulation software configured
to the following parameters:
• VT100 terminal emulation
• 9600 bps
• No parity, 8 data bits, 1 stop bit
• No flow control
Connect the male 9-pin end of the console cable to the console port of the switch. Connect the
female end to a serial port (COM1, COM2 or other COM port) of your computer.
3.1.2 Ethernet Ports
The switch has 48 10/100 Mbps auto-negotiating, auto-crossover Ethernet ports. In 10/100
Mbps Fast Ethernet, the speed can be 10 Mbps or 100 Mbps and the duplex mode can be half
duplex or full duplex.
There are two pairs of Gigabit Ethernet/mini-GBIC ports. The mini-GBIC ports have priority
over the Gigabit ports. This means that if a mini-GBIC port and the corresponding Gigabit port
are connected at the same time, the Gigabit port will be disabled. The speed of the Gigabit
Ethernet/mini-GBIC ports can be 100 Mbps or 1000 Mbps and the duplex mode can be half
duplex (at 100 Mbps) or full duplex.
An auto-negotiating port can detect and adjust to the optimum Ethernet speed (100/1000
Mpbs) and duplex mode (full duplex or half duplex) of the connected device.
An auto-crossover (auto-MDI/MDI-X) port automatically works with a straight-through or
crossover Ethernet cable.
42
DESCRIPTION
Connect these ports to a computer, a hub, an Ethernet switch or router.
Each interface has one 1000 BASE-T copper RJ-45 port and one Small Form-Factor
Pluggable (SFP) fiber-optic port, with one port active at a time.
Connect these Gigabit Ethernet ports to high-bandwidth backbone network Ethernet
switches or use them to daisy-chain other switches.
Use mini-GBIC transceivers in these slots for fiber-optic connections to backbone
Ethernet switches.
Only connect this port if you want to configure the switch using the command line
interface (CLI) via the console port.
Connect to a computer using an RJ-45 Ethernet cable for local configuration of the
switch.
ES-2048 User's Guide