Paidfeatures - Cisco ATA-186 Administrator's Manual

Operating Parameters

PaidFeatures

Description
Unsubscribe/subscribe to CallFeatures by setting each corresponding bit to either 0 or 1. The lower 16
bits are for the Phone 1 port, and the upper 16 bits are for the Phone 2 port.
definitions of each bit.
Value Type
Bitmap
Default
0xffffffff
Voice Configuration Menu Access Code
315
Table 5-3 PaidFeatures Parameter Bit Definitions
Bit Number Definition
0 Forward unconditionally
1 Forward on busy
2 Forward on no answer
3 CLIP_CLIR
4 Call waiting
5 three-way calling
6 Blind transfer
7 Transfer with consultation. This service allows the user to transfer the remote party to a different number by
first calling that number and consulting with the callee.
8 Caller ID. This service enables the Cisco ATA 186 to generate a Caller ID signal to drive a Caller ID display
device attached to the FXS line.
9 Call return
10 Message waiting indication
11 Call Waiting Caller ID. This is available only if the Method bit in CallerIdMethod is set to Bellcore (FSK).
15 Fax mode. This service allows the user to set the Cisco ATA to Fax mode on a per-call basis. For Fax mode, use
the following settings:
G.711 codec only
•
No silence suppression
•
No FAX tone detection
•
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SIP)
5-24
Chapter 5 Parameters and Defaults
Table 5-3 provides
OL-3410-01