Call Command Example - Cisco ATA-186 Administrator's Manual

Chapter 6 Call Commands
Table 6-3
c
d
e
f
g
h
i
x
y

Call Command Example

In addition to call commands that you configure, the Cisco ATA has a default list of call commands to
handle common call scenarios. Configured call commands overwrite default call commands. If any
Context-Identifier or Input-Sequence elements appear in both the default Call Command string and the
manually entered string, the manually entered value takes precedence.
The following string shows a sample Call Command:
Bf;BAN;CA;CN;CAf;OF;Df;EB;I@f;OF;H@f;OA;Lo;BAf;BA;Mo;PA;ND;CAf;OA;Of;GA;Pf;HA;Qf;OA;Rf;OA;
Sf;OA;TD;CAf;OF;Uf;GF;Vf;HF;Wf;FF;Xf;AF;Yf;AF;Zf;AP;bf;OF;af;OP;
In this section, the Call Command string is broken down into its components as follows:
Call Command Fragment;
Note
Refer to the preceding tables to determine the meanings of the identifiers.
Example 6-3
Bf;BAN;CA;
CN;CAf;OF;
Df;EB;
I@f;OF;
H@f;OA;
OL-3410-01
Action Identifiers (continued)
Forward on busy to the given number
Forward on no answer to the given number
Cancel call forward
CLIP for the next call
CLIR for the next call
Enable Call Waiting for the next call
Disable Call Waiting for the next call
Enable Fax Mode for the next call
Disable Fax Mode for the next call
Context-Identifier
Input-Sequence1; Action1 Action2;
(optional) Input-Sequence2; Action1 Action2;
If you use a second input sequence, this sequence follows the Action Identifier pair without a
separating semicolon.
Call Command String
Predial
hook-flash; Seizure NONE
0|1|...|9; Continue-to-dial NONE;
Predial_Holding
0|1|...|9; Continue-to-dial NONE
hook-flash; Release-the-call Retrieve-the-waiting-call;
Connected
hook-flash; Hold-the-active-call Seizure;
Configuring_Holding
hook-flash (at any time); Release-the-call Retrieve-the-waiting-call;
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SIP)
Call Command Example
6-5