Download Print this page

F&F LK-701R Quick Start Manual

Indicator lamp 1x red

Advertisement

Quick Links

LK-701R
Indicator lamp
(1× red)
Do not dispose of this device in the trash along with other waste!
According to the Law on Waste, electro coming from households free of charge and can
give any amount to up to that end point of collecti on, as well as to store the occasion of
the purchase of new equipment (in accordance with the principle of old-for-new, regard-
less of brand). Electro thrown in the trash or abandoned in nature, pose a threat to the
environment and human health.
Purpose
The LK-701R indicator lamp is used to visually signal the pre-
sence of voltage in an electrical circuit. The small size of the
housing (width 6.2 mm) allows space-saving installation in the
switchgear.
Functioning
The presence of voltage in the circuit is indicated by the red LED
lighting up.
Where an overcurrent fuse equal to or greater than 25 A
is installed upstream of the lamp connection point, the
lamp connection circuit must be fused with a fuse no
greater than 6 A.
F&F Filipowski L.P.
Konstantynowska 79/81, 95-200 Pabianice, POLAND
phone/fax (+48 42) 215 23 83 / (+48 42) 227 09 71
www.fif.com.pl; e-mail: biuro@fif.com.pl
- 1 -

Advertisement

loading
Need help?

Need help?

Do you have a question about the LK-701R and is the answer not in the manual?

Questions and answers

Summary of Contents for F&F LK-701R

  • Page 1 Electro thrown in the trash or abandoned in nature, pose a threat to the environment and human health. Purpose The LK-701R indicator lamp is used to visually signal the pre- sence of voltage in an electrical circuit. The small size of the housing (width 6.2 mm) allows space-saving installation in the switchgear.
  • Page 2 Mounting 1. Check input signal. 2. Disconnect the power supply. 3. Fix the light on the rail. 4. Connect according to the diagram. 5. Switch on the power supply. 6. Check for correct operation. Wiring diagram - 2 -...
  • Page 3 Technical data power supply 230 V+N rated current <1 mA power indication 1× LED (red) power consumption <0.15 W working temperature -30÷50°C terminal 2.5 mm² screw terminals tightening torque 0.4 Nm dimensions 1/3 module (6.2 mm) mounting on TH-35 rail ingress protection IP20 Warranty...