Skoda SUPERB - 05-2010 Owner's Manual page 95

94 Seats and Stowage
Removing and installing the variable loading floor* (Combi)
Fig. 89 Luggage compartment: Fold up variable loading floor
Fig. 90 Luggage compartment: remove variable loading floor
You can remove and reinstall the variable loading floor, if necessary.
Removing the variable loading floor
– Grasp the rear part of the floor at the handle, raise it slightly in direction of arrow
A  fig. 89
and pull it over the bumper in direction of arrow
1
A  fig.
in the opening 90.
C
– You can fold together the loading floor by moving it in direction of arrow
 fig.
89.
A  fig. 90
– Press the safety buttons
A
Installing the variable loading floor
– Fold together the floor and place it on the carrier rail.
A
until it engages
2
A
3
and remove the floor.
– Push the floor forwards until it engages in the openings
carrier rails.
– Carefully press on the points of the openings
in place, if necessary press the safety buttons
WARNING
Pay attention when installing the variable loading floor that it is correctly
attached. If this is not the case, there is a risk of injury for the occupants.
Fixing set* (Combi)
Fig. 91 Telescopic pole and tensioning strap
The fixing set can be used for dividing the luggage compartment or for securing the
objects which are being transported.
Telescopic pole
– Insert the holder for the telescopic pole on the left and right into the openings of
the carrier rails.
– Press the top part of the holder in direction of arrow
same time in the desired position, arrow
– Ensure that the holder is correctly interlocked.
A  page 94, fig. 90
in the
B
A
on the floor until it is heard to lock
C
A
.
A
A  fig. 91
and push it at the
1
A
.
2