Skoda SUPERB - 05-2010 Owner's Manual page 84

– Press the unlock button  page 49, after the successful assignment an audible
signal will sound. The setting is stored with the memory button which you have
selected.
Assigning the remote control key to the memory buttons on the KESSY*
system
On vehicles which are equipped with the KESSY* system, the following procedure for
assigning the remote control key to the memory buttons exists for electrically adjust-
able front seats and mirrors*.
– Switch the ignition off within 10 seconds after storing the setting.
– Open the driver door.
– Press the unlock button on the remote control key within 10 seconds.
If you wish to be able to retrieve the settings which are stored in the memory by also
using the radio remote control, you have to assign the radio remote control to a
memory button in each case.
If you wish, you can obtain an additional remote control key from an authorised Škoda
Service partner and then assign the remote control key to another memory button.
Note

If the radio remote control had previously been assigned to another memory
button, this setting is then erased by the new assignment.

If you assign the radio remote control to a memory button which has already been
assigned to a radio remote control, the old assignment is also replaced by a new
assignment in this case.

The assignment of the radio remote control to a memory button is retained,
however, after reassigning the seats and exterior mirrors.

After the successful assignment, the turn signal lights flash and an audible signal
will sound as a confirmation. The setting is stored with the memory button which you
have selected.
Using the system Safety
Retrieving settings of the seat and mirrors
You can retrieve the stored settings either with the memory buttons or
with the remote control*.
Retrieving settings with memory buttons
– In order to retrieve the stored setting, you have two possibilities:
– One-touch automatic memory: briefly press the desired memory button
– Memory keying: Press and hold the desired memory button
Retrieving settings with remote control
– If the driver door is closed and the ignition is switched off, briefly press the unlock
– The seat and exterior mirrors now move automatically into the stored positions.
Retrieving setting of exterior mirror for reversing*
– Turn the rotary knob for the exterior mirror setting into the position
The mirror returns into its initial position, after the rotary knob is moved out of the
position
Emergency Off
You can interrupt the setting operation at any time, if you operate any button of the
driver seat.
Driving Tips General Maintenance
 page 82, fig.
70. The seat and exterior mirror are moved automatically into the
stored positions (this applies only if the ignition is switched on and the speed is less
than 5 km/h).
enough until the seat and the exterior mirror are moved into the stored positions.
button of the radio remote control  page 49 and then open the driver door.
before engaging the reverse gear.

and put into another position or if the speed is more than 15 km/h.
Breakdown assistance
Seats and Stowage 83
A
B
A
pressed long
B
  page 77
Technical Data