Skoda SUPERB - 05-2010 Owner's Manual page 254

A  page 252, fig.
– Remove the socket
A
– Take the faulty bulb out of the fixture and insert a new one.
Removing the light bulb for the main beam light
– Switch the ignition and all lights off.
– Open the bonnet.
– Remove the protective cap
– Press the sprung wire clamps
the side.
A  page 252, fig.
– Remove the socket
C
– Take the faulty bulb out of the fixture and insert a new one.
Installation takes place in the reverse order.
Note
We recommend that you have the headlight setting checked by a Skoda Service
Partner after replacing the light bulb.
Low beam light
– Switch the ignition and all lights off.
– Open the bonnet.
– Remove the protective cap
Using the system Safety
211.
A  page 252, fig.
210.
A
A  page 252, fig. 211
together and hang them to
B
211.
Fig. 212 Removing the light bulb for the
low beam light
A  page 252, fig.
210.
B
Driving Tips
– Turn the connector with the light bulb up to the stop towards the left and remove
 fig.
212.
– Replace the lamp, insert the connector with the new lamp and turn to the right up
to the stop.
– Insert the protective cap.
Note
We recommend that you have the headlight setting checked by a Skoda Service
Partner after replacing the light bulb.
Fog lights
Fig. 213 Front bumper: Cover / fog lights with daylight driving lights
Replacing bulbs
– Switch the ignition and all lights off.
– Grasp the cover at the points marked with the arrows
out.
– Guide your hand into the opening, in which the cover was located, and press the
 fig.
A
spring bolt 213.
C
– Take out the fog light.
A A
– Turn the socket or with the bulb to the left up to the stop and take it out.
A B
– Replace the lamp, insert the connector with the new lamp and turn to the right up
to the stop.
General Maintenance Breakdown assistance
Fuses and light bulbs 253
 fig. 213
- left and take it
Technical Data