Skoda SUPERB - 05-2010 Owner's Manual page 67

66 Lights and Visibility
 page 65, fig. 50
– Turn the control dial
that oncoming traffic is not dazzled.
Settings
The positions correspond approximately to the following vehicle loads:
A
Front seats occupied, luggage compartment empty.
-
A
All seats occupied, luggage compartment empty.
1
A
All seats occupied, luggage compartment laden.
2
A
Driver seat occupied, luggage compartment laden.
3
Caution
Set the headlight beam adjustment in such a way as to avoid dazzling oncoming traffic.
Note
The Bi-Xenon bulbs* adapt automatically to the load and driving state of the vehicle
(e.g. speed, accelerating, braking) when the ignition is switched on and when driving.
Vehicles which are not equipped with Bi-Xenon bulbs* do not have a manual headlight
range adjustment control.
Switch for hazard warning lights
 fig. 51
– Press switch  to switch the hazard warning light system on or off.
All the turn signal lights on the vehicle flash at the same time when the hazard warning
light system is switched on. The indicator light for the turn signals and the indicator
until you have adjusted the low beam so

Fig. 51 Dash panel: Switch for hazard
warning lights
light in the switch also flash at the same time. You can also switch on the hazard
warning light system if the ignition is switched off.
The hazard warning light system is switched on automatically if an airbag is deployed
in the event of an accident.
Please comply with any legal requirements when using the hazard warning light
system.
Note
Switch on the hazard warning light system if, for example:

you encounter traffic congestion,

your vehicle breaks down or an emergency situation occurs.
The turn signal   and main beam lever
The parking lights and headlight flasher are also switched on and off
using the turn signal and main beam lever.
The turn signal and main beam lever perform the following functions:
 
Right and left turn signal light
A  fig. 52
– Push the lever upwards
A
– If you only wish to flash three times (the so-called convenience turn signal), push
the lever briefly up to the upper or lower pressure point and release it. This function
can be activated/deactivated in the information display*  page 25.

Fig. 52 Turn signal and main beam lever
A
or downwards .
B