Skoda SUPERB - 05-2010 Owner's Manual page 83

82 Seats and Stowage
WARNING (continued)

The seat backrests must not be angled too far back when driving otherwise
this will affect proper operation of the seat belts and of the airbag system - risk
of injury!
Note
If the movement of the seat is inadvertently interrupted during an adjustment, once
again press the switch in the appropriate direction and continue with the adjustment
of the seat to the end.
Storing setting
Storing seat and exterior mirror settings for driving forward
– Switch on the ignition.
– Adjust the seat  page 81.
– Adjust both exterior mirrors  page 77.
A  fig.
– Press button SET 70.
A
– Press one of the memory buttons
SET - an acknowledgement signal confirms that the seat setting is stored.
Storing exterior mirror setting for reversing*
– Switch on the ignition.
Fig. 70 Driver seat: Memory buttons
and SET button
A
within 10 seconds after pressing the button
B
– Turn the exterior mirror control to position
– Engage the reverse gear.
– Move the right exterior mirror into the desired position  page 77.
– Take the vehicle out of gear. The set position of the exterior mirror is stored.
Memory buttons
Memory for the seat offers the possibility to store the individual driver seat and
external mirror position. An individual position can be allocated to each of the three
A  fig.
memory buttons 70, that is three in total. After pressing the corresponding
B
A
memory button , the seat and the exterior mirror are automatically moved into the
B
positions which have been allocated to this button  page 83.
Emergency Off
You can interrupt the setting operation at any time, if you operate any button of the
driver seat.
Note

For safety reasons, it is not possible to store this position if the inclination angle of
the seat backrest is more than 102° in relation to the seat cushion.

When storing settings with the memory buttons, we recommend that you begin
with the front button and assign a memory button to each additional driver.

Each new setting stored with the same button erases the previous setting.

Each time you store the seat and exterior mirror settings for driving forward you
also have to re-store the individual setting of the exterior mirror on the passenger side
for reversing.
Assigning the remote control key to the memory buttons
Assigning the remote control key to the memory buttons
After storing the settings of the seat and exterior mirrors, you have 10 seconds in order
to assign the radio remote control to the appropriate memory button.
– Withdraw the ignition key.
 page 77.
