Sequential Operations - Freecom SUPERLOADER3 LTO2-HH Manual

Sequential
Operations 4
1 From any page, click the
displays.
2 From the
Commands
command to the autoloader.
The

Sequential Operations

that do not manage media. During backup, when one cartridge is read or
written to the end of the tape, the autoloader automatically returns that
cartridge to its designated slot and loads the cartridge from the next
higher numbered slot to the tape drive to be read or written to. This
continues until the backup software stops accessing the drive or until all
the cartridges have been sequentially accessed. The autoloader does not
move the media until the host requests the tape drive to unload.
1 From any page, click the
displays.
2 From the
Commands
3 To start
Sequential Operations
available cartridge from the storage slot to the drive.
• To stop
Sequential Operations
from the drive and places it back into the cartridge's previous storage
slot.
• To resume
Sequential Operations
cartridge to the tape drive.
You must perform a
Note:
cartridge into the tape drive before starting a host backup.
SuperLoader 3 Autoloader User's Guide
Chapter 4 On-board Remote Management
heading. The
Commands
page, click
Set to Home
mode supports certain backup applications
heading. The
Commands
page, scroll to
Sequential Operations
, click . This moves the first
Start
, click . This removes the cartridge
Stop
, click
Resume
or
Start Resume
Commands Page
screen
Commands
. This executes a reset
screen
Commands
.
. This moves the next
command to load a
57