Yamaha MOTIF ES6 Owner's Manual page 231

08: Beat Stretch
TR (Track)
001 : 1 : 000 - 999 : 4 : 479
Rate
[F4] MEAS (Measure Job)
01: Create Measure
Meter of measures to be inserted
Insertion point
(Measure number)
Number of measures to be
inserted
n
When empty measures are inserted, measure and meter data following the insert point are moved forward accordingly.
n
If the insert point is set after the last measure containing data, only the meter data at that point is set without actually inserting the measures.
02: Delete Measure
Delete Range
[F5] TRACK (Track Job)
01: Copy Track
Data Type to be copied
n
When there is no memory available in the destination Song for sample voice data, an alert message will appear on the display and the Sample Voice data will not be
copied. If this occurs, use Sample Job 02 "Delete" (page 256) to delete any unused samples, then attempt the operation again.
This Job performs time-expansion or compression over the selected range. Keep in mind that this operation affects
all event timing, note step times, and note gate times.
Determines the track (01 - 16, all) and range of measures/beats/clocks over which the Job is applied.
Determines the amount of time expansion or compression as a percentage. Settings higher than 100% produce
expansion, and settings below 100% produce compression.
Settings: 025%~400%
n
Only MIDI data is affected by this Job. Sample Voices are not expanded or compressed. However, for samples recorded using
the Slice+Seq feature, the Beat Stretch Job expands or compresses the timing of the note data, step times, and gate times
that control playback of the sliced samples. The sample data itself is not affected.
This Job creates empty measures at the specified location in all tracks.
Number of measures
Meter (time signature) of
to be inserted
measures to be inserted
Insertion point (measure number)
Determines the meter or time signature of the measures to be created. You may find it convenient to use this
parameter when you need to create a Song that incorporates meter changes.
Settings: 1/16~16/16, 1/8~16/8, 1/4~8/4
Determines the insert point (measure number) at which the newly created blank measures will be inserted.
Settings: 001~999
Determines the number of empty measures to be created and inserted.
Settings: 01~99
This Job deletes the specified measures. Measure and meter data following the deleted measures are moved
backward accordingly.
Delete range
Settings: 001~999
n
Keep in mind that applying this Job to a range of measures with Sample Voices erases the events that trigger the samples, but
it does not erase the actual samples themselves.
Source Song and Track Destination Song and Track
Data Type to be copied
Determines the type(s) of data to be copied. Select the desired type by checkmarking the appropriate box.
Settings: Seq Event (all events in the track), Grid Groove (for the selected track), Mix Part Param (all Mixing Part parameters), Sample
(all samples used by the track)
Source data
001 – 004 005 – 016
8 measures inserted at measure 5
001 – 004 005 – 012 013
The inserted 8 measures
Source data
001 – 004 005 – 012 013
Measures M006 – M012 deleted
001 – 004 005 – 016
This Job copies all data from a specified source track
to the specified destination track.
CAUTION
The copy operation overwrites any data
previously existing on the destination
track.
CAUTION
Undo/Redo cannot be used to undo/
redo a sample voice copy operation.
Owner's Manual
Song Job mode
– 024
– 024
231