Yamaha MOTIF ES6 Owner's Manual page 155

Controller related parameters in each mode
The chart below shows the operations for calling up the Controller related parameters in each mode. Parameters for the
Footswitch and the Assign Knobs A/B apply to the entire instrument, regardless of the selected program (Voice/Performance/
Song/Pattern).
Controller Set (for each Voice)
Voice mode
Assigning the Control Change number to each
Controller (for all Voices)
Performance Assigning the Control Change number to each
mode Controller (for each Performance)
Assigning the Control Change number to each
Song mode
Controller (for each Song Mixing)
Assigning the Control Change number to each
Pattern mode
Controller (for each Pattern Mixing)
Assigning the function and Control Change
number to the Assign Knob A/B
All modes
Assigning the function and Control Change
number to the Footswitch (connected to the
ASSIGNABLE connector)
Controller Set
Aside from their default control parameters, the controllers of the instrument, such as the Pitch Bend wheel and the Modulation
wheel, can be freely assigned to a variety of different parameters. For example, you could assign Resonance to the Modulation
Wheel and set aftertouch to apply vibrato. These settings for all the controllers are referred to as a "Controller Set," and up to six
Controller Sets can be created for each Voice.
Controller Set 1 - 6
n You can set whether the controller affects each
Element by setting the Element Switch on or off as
desired. Note that this applies only to Normal Voices.
n The Element Switch parameters are not available
when a function unrelated to Elements (1 - 40) is set
as the destination.
Source and Destination
"source" refers to the hardware controller and "destination" refers to the parameter or function being controlled. An extensive
variety of destination parameters are available, far more than those listed above. For a complete list of destination parameters,
see the separate Data List.
[VOICE]
[VOICE]
[PERFORM]
[F4] CTL ASN
[SONG]
[F4] CTL ASN
[PATTERN]
[F4] CTL ASN
[UTILITY]
[UTILITY]
[VOICE] Voice selection
Voice
Voice selection [EDIT]
[UTILITY] [F3] VOICE [SF4] CTL ASN
Performance selection
Song selection [MIXING]
Pattern selection [MIXING]
[F4] CTL ASN [SF2] ASSIGN
[F4] CTL ASN [SF3] FT SW
[EDIT] [COMMON]
Controller Set
Source = Controller
SWING GATE TIME
KN 1 KN 2
LOW LOW MID
Depth = Degree to which the
controller affects the sound
Element Switches
ON/OFF ON/OFF ON/OFF ON/OFF
1 2 3 4
Destination (Dest) = function
Volume, Reverb Send Level, Chorus Send Level, Filter
Cutoff Frequency, Filter Resonance, etc.
Internal Structure (System Overview)
[COMMON] [F4] CTL SET See below.
Page 262
[EDIT] [COMMON]
Page 214
[EDIT] [COMMON]
Page 234
[EDIT] [COMMON]
Page 248
Page 263
Page 263
[F4] CTL SET Page 192
Owner's Manual
155