Liquid Propane Cylinder Connection; Hose To Cylinder Connection; Check For Gas Leaks - Weber Q-320 Owner's Manual

Lp gas grill
Hide thumbs Also See for Q-320:
Table of Contents

Advertisement

Available languages

Available languages

liQuid PRoPAne CYlindeR ConneCtion

m wARninG: make sure that the lP cylinder valve is closed.
Close by turning valve clockwise.

hose to CYlindeR ConneCtion

m wARninG: the hose must be secured to the cart leg by the
hose retention clip (1). failure to do so could cause damage
to hose resulting in a fire or explosion, which can cause
serious bodily injury or death and damage to property.
A) Remove the plastic dust cover from the tank valve.
B) Screw the hose coupling onto the tank valve, turning clockwise, or to the right (2).
Hand-tighten only.
Note: This is a new type of connection. It tightens clockwise and will not allow gas to
flow unless the connection is tight. The connection requires tightening by hand only.
m wARninG: do not use a wrench to tighten the connection.
using a wrench could damage the regulator coupling and
could cause a leak.

CheCK foR GAs leAKs

Check that the burner Valves are off
To turn the burner valves off, push both control knobs in and turn clockwise. When knobs
cannot be turned further, confirm that they are both set to the OFF position. Proceed to
the next step.
m wARninG: You should check for gas leaks every time you
disconnect and reconnect a gas fitting.
m wARninG: Perform these leak checks even if your barbecue
was dealer or store assembled.
m wARninG: do not ignite burners when leak checking.
m dAnGeR
do not use an open flame to check for gas leaks. be sure
there are no sparks or open flames in the area while you
check for leaks. sparks or open flames will result in a fire or
explosion, which can cause serious bodily injury or death
and damage to property.
A) Mix soap and water.
B) Turn on the cylinder valve by turning cylinder valve handwheel counter-clockwise (3).
C) Check for leaks by wetting the fittings with the soap and water solution and watching
for bubbles. If bubbles form, or if a bubble grows, there is a leak.
m wARninG: if there is a leak, turn off the gas and tighten the
fittings. turn the gas back on and recheck with the soap and
water solution. if leak does not stop, Contact the Customer
service Representative in your area using the contact
information on our web site. log onto www.weber.com
do not use the barbecue.
GAS INSTRUcTIoNS
.
®
1
2
3
WWW.WEbER.com
®
25

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Q-30041060

Table of Contents