Network Deployment; Setting Up The Network Camera Over The Internet; Internet Connection Via A Router - Vivotek FD8361L User Manual

VIVOTEK

Network Deployment

Setting up the Network Camera over the Internet

This section explains how to configure the Network Camera to an Internet
1� Connect the power cable to the AC 24V terminal block�
2. Use the supplied RJ45 female/female coupler to connect the Network Camera to a switch.
Use a Category 5 Cross Cable when Network Camera is directly connected to PC�
There are several ways to set up the Network Camera over the
up the Network Camera behind a
to use PPPoE�

Internet connection via a router

Before setting up the Network Camera over the Internet, make sure you have a router and follow
the steps below�
1� Connect your Network Camera behind a router, the Internet environment is illustrated below�
Regarding how to obtain your IP address, please refer to Software Installation on page 13 for
details�
Internet
10 - User's Manual
router� The second way is to utilize a static
WAN (Wide Area Network ) WAN (Wide Area Network )
Router IP address : from ISP P Router IP address : from ISP
LAN (Local Area Network) LAN (Local Area Network)
Router IP address : Router IP address : 192.168.0.1
Cable or DSL Modem
AC24V: Power in AC 24V
AC24V
AC24V: Power in AC 24V
AC24V
Internet�
IP address : 192.168.0.3
Subnet mask : 255.255.255.0
Default router : 192.168.0.1
IP address : 192.168.0.2
Subnet mask : 255.255.255.0
Default router : 192.168.0.1
connection�
The first way is to set
IP� The third way is