ekwb EK-Quantum Vector3 Astral RTX 5090 User Manual page 15

OUTLET
EK- PLUG G1/4
EK-FITTING
TUBING
INLET
CONNECTING THE D-RGB LED
STEP 1
D-RGB HEADER
RGB HEADER
STEP 1
- 15 -
STEP 1
Screw in two (2) G1/4 threaded male fittings. Attach the liquid
cooling tubes and connect the water block to the cooling loop.
Do not forget to plug the remaining two openings using
the enclosed EK-Plug G1/4 or its equivalent.
EK recommends using EK fittings with all EK water blocks.
CAUTION: When using connectors other than EK fittings,
pay special attention to the length of the fittings' male G1/4"
thread – 5mm is the maximum G1/4" thread length allowed!
For this step, you will need:
EK-Loop Multi Allen Key
STEP 1
Plug the 3 Pin connector from the water block's D-RGB LED light to
the DRGB HEADER on the motherboard. The LED will work if the pin
layout on the header is as follows: +5V, Digital, empty, Ground.
Please ensure that the arrow indicated on the connector is
plugged into the +5V line as indicated on your
motherboard. If you put the LED Diode to the 12V RGB
HEADER you can damage the LEDs. Failure to do so will
damage your motherboard or LED strip.