Britax COMPAQ Instructions For Installation & Use page 12

FOR
BABY
USE
A single twist
is required for
easy access to the
Upper Anchorage
Adjuster.
Do not use this slot for
baby use installation
Front of
vehicle
Note: Seat belt buckle and tongue must not rest between restraint cover and restraint. If the
seat belt buckle is adjustable, adjust the buckle as low as possible away from the restraint.
H. Push down on the restraint while pulling the sash portion of seat belt until all slack is
removed from Lap portion of seatbelt. Adjust seat belt to hold the restraint firmly against
the vehicle seat back. For retractor seat belts, allow
excess belt to feed back into retractor.
I. Fit the attachment clip to the anchor fitting as shown
right. Make sure to remove as many twists as
possible from the upper anchorage strap.
J. Tighten adjustable upper anchorage strap by pulling adjustment strap to remove slack,
but do not over-tighten causing the restraint base to lift off the vehicle seat.
WARNING: DO NOT USE RESTRAINT IN REARWARD FACING MODE WITHOUT
STABILISING BAR FULLY EXTENDED.
12
Rearward Facing (Up to 12 kg)
Ensure seat is in
full recline
position for baby
use.
HOW TO INSTALL
Ensure all slack is
removed from Upper
Anchorage
Strap.
Pull sash portion of seat
belt to remove slack from
lap portion of belt.
Feed seat belt between
restraint cover and
restraint body. (See
previous page)
Fully press Adjuster Button (A)
while pulling Upper Anchorage
Strap (B) to lengthen.
A
Storage
Strap
Pull Adjustment Strap
to remove slack
Attachment
Clip & Cover
B
Anchor
fitting