How To Install - Britax COMPAQ Instructions For Installation & Use

Consult the vehicle owner's handbook for location of anchor fittings or anchorage points
and the possible use of spacers. Some vehicles may have an anchor fitting fitted by the
vehicle manufacturer. If anchorage points cannot be found refer to car manufacturer or
local child restraint fitting station or traffic authority for optimum position of anchorage
point and the use of spacers.
UPPER ANCHORAGE STRAP
IMPORTANT WARNING: THE ATTACHMENT CLIP COVER MUST ALWAYS BE USED AS
IT PREVENTS THE RISK OF INCORRECT FITMENT OF THE ATTACHMENT CLIP TO
THE ANCHOR FITTING. ALWAYS ENSURE THAT THE ATTACHMENT CLIP IS
CORRECTLY ENGAGED TO THE ANCHOR FITTING AND NOT HOOKED OR FITTED TO ANY
OTHER OBJECT BEFORE EACH USE OF THE RESTRAINT. THIS IS ESPECIALLY
IMPORTANT IN VEHICLES SUCH AS STATION WAGONS, VANS, HATCH BACKS OR
VEHICLES WITHOUT A FIXED PARCEL SHELF, SINCE THE ANCHOR POINT IS USUALLY
NOT VISIBLE.
IMPORTANT INSTALLATION NOTE:
In some vehicles the anchor fitting in the rear vertical panel can only be installed in one
way. Please refer to vehicle owner's
handbook or a child restraint fitting station for
correct method.
Front of
vehicle
Adjustable upper
anchorage strap.
The shaded areas of this diagram illustrate the possible locations of the anchor fitting. Within each
shaded area is an anchor fitting showing the correct way to install the fitting. Ensure the anchor
fitting is aligned as illustrated unless stated otherwise in the vehicle owner's handbook.
4
Forward & Rearward Facing

HOW TO INSTALL

Extension Strap distance to be measured:
Length 300mm -
(Use Safe-n-Sound part 0035 or equivalent).
Length 600mm -
(Use Safe-n-Sound part 0036 or equivalent).
Available from all major child restraint retailers.
Rear facing installation may require a longer
extension strap.
CORRECT ENGAGEMENT
OF ATTACHMENT CLIP TO
ANCHOR FITTING.