Trotec Promarker Operation Manual page 15

Promarker
Operation Manual
5 Before Commissioning
09/01/2012 Trotec Produktions- und Vertriebs GmbH_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, e-mail:
Read the operation manual and ensure it is accessible at all times.
•
The ambient air temperature must be between +15° C und +35° C
•
and the relative air humidity not exceed 90% (non-condensing).
A laser system consists of high quality electrical and optical
•
components. Mechanical stresses, vibrations and impacts must
always be avoided.
If the system has been subject to significant temperature
•
variations, it must be brought back to room temperature before
being commissioned.
Sufficient air must be supplied to the 19" module of ventilated
•
systems. The accumulation of heat due to covered ventilation slots
or filter pads can damage the system.
Assemble the device at the point of installation according to the
•
instructions.
The operating personnel must read and understand the operation
•
manual, in particular the chapter on "Safety Instructions". It is
recommended that the operator compiles with in-house
instructions regarding safety and operation and that the receipt of
these instructions/operation manual and the participation in
briefings/training courses is confirmed in writing.
Laser marking may generate gases, fumes and other reaction
•
products on the surface of the material. The operator must
therefore use an effective extraction system.
techsupport@troteclaser.com
15 / 43