Table of Contents
Advertisement
S
S
UPER
ERVER 1025TC-T/1025TC-10G User's Manual
1-2
Serverboard Features
At the heart of the SuperServer 1025TC-T/1025TC-10G lies two X7DCT/X7DCT-
10G dual processor serverboards, which are based on Intel's 5100 chipset. Below
are the main features of the X7DCT/X7DCT-10G. Note that the features on each
board are doubled for the server.
Processors
Each X7DCT/X7DCT-10G supports dual Intel® Xeon® 5400/5300/5200/5100 Series
processors. Please refer to our web site for a complete listing of supported proces-
sors (www.supermicro.com).
Memory
The X7DCT/X7DCT-10G has six 240-pin DIMM sockets that can support up to 48
GB of registered ECC DDR2-667/533 SDRAM. Memory can be installed in both
interleaved (dual-channel) and non-interleaved (single-channel) confi gurations. All
memory modules used to populate the system should be the same size, type and
speed.
Serial ATA
The South Bridge (ICH9R) of the chipset includes a Serial ATA controller for six
Gb/s SATA drives. The hot-swappable SATA drives are connected to a backplane
that provides power, bus termination and confi guration settings. RAID 0, 1, 5 and 10
are supported (RAID 5 is not supported by Linux OS). Refer to the support area
of our web site for procedures on setting up RAID on your system.
PCI Expansion Slots
Each X7DCT/X7DCT-10G board has one PCI-Express 2.0 x16 slot, so two PCI-
Express 2.0 x16 slots are provided in the server. In the 1025TC-T/1025TC-10G
server confi guration, riser cards have been pre-installed to support two low-profi le
PCI-Express x16 add-on cards.
Ethernet Ports
Two Intel® network controllers (one 82573V and one 82573L) are integrated into
each of the serverboards to support a total of four Gigabit LAN ports (100/1000Base-
T/1000BaseTX, RJ45 output).
1-2
Advertisement
Table of Contents
