Main Menu; Configuration - Sencor SIR 5100WDB User Manual

Warning:
The manual describes the software status at the time of manufacture. Software is subject to
development and updates for improved performance and user experience. Future updates
may slightly alter the appearance or behaviour.

MAIN MENU

In the main menu, you can select the following modes: Internet Radio, USB, Podcast, FM, DAB,
Bluetooth, AUX in, Local Radio, Configuration/Settings.
To navigate through the menu, use the cursor key RIGHT (enter a submenu), LEFT (back, higher,
ESC), UP/DOWN (select items), OK to confirm the selection.

Configuration

The device is factory-configured to work under normal conditions. Explore the rich customisation
options to tailor the usage to your needs under the following settings:
Device – Naming, system information, DAB software and firmware versions, wireless info.
Equaliser – Audio curve settings for music: normal, flat, classical, pop, rock, jazz.
Network – Wireless network settings (enable), maintain connection in standby mode (slightly
increases power consumption).
Dimmer – Brightness settings for the display in operating and standby modes.
Alarm - 1. Alarm 2, Alarm, volume. For each alarm, choose repetition, wake-up time, and sound
(beep, melody, radio – use a strong enough station for both alarms). An active alarm is shown with
the symbol at the top of the display.
Timer-Minute – counts down the set time min-sec, after it expires it starts beeping.
Power management – To turn off the device after a certain period without manual operation or WiFi
signal, this function can be completely disabled.
Sleep timer – To "sleep" the device after a set time (Off, 15 min,... up to 180 min).
Date and time – Setting the current date and time, as well as date and time format, either manually
(accuracy depends on you) or automatically (the device will pull the correct date and time from the
internet or broadcast, if available; the provider determines the time zone and daylight savings).
Time display – Choose the colour of the clock on the display in standby mode
Local stations settings – Select from the global network of internet radios, an active internet
connection is required.
Weather – You can set your monitored location, choose the temperature unit, and display it on the
screen in standby mode.
FM settings – Choose Mono or Stereo playback, sensitivity (adjust based on the strength of stations
in your area and noise level).
Playback settings – Choose between normal playback, repeat or shuffle.
Language – Select from many OSD languages.
Resume playback on power-up – Choose whether the device should return to the main screen with
mode selection or continue playing from where it left off after turning on
Copyright © 2024, Fast ČR, a.s.
EN
EN 11
Revision 10/2024