Xylem JABSCO SENSOR-MAX II Installation And Operation Manual page 2

SENSOR-MAX II — Automatic Water System Pump
CAUTION: Read this manual carefully before
installing, using or servicing this product. Failure
to follow the instructions within this manual
could result in explosion, property damage,
severe personal injury and/or death.
NOTICE: Save this manual for future reference,
and keep it readily available at the location of
the unit.
Safety
WARNING:
• The operator must be aware of safety precau-
tions to prevent physical injury.
Operating, installing or maintaining the unit
•
in any way that is not covered in this manual
could cause death, serious personal injury
or damage to the equipment. This includes
any modification to the equipment or use
of parts not provided by Xylem. If there is
a question regarding the intended use of
equipment, please contact a Xylem represen-
tative before proceeding.
User safety
General safety rules
These are safety rules apply:
• Always keep work area clean
• Pay attention to the risks presented by gas and vapors in the
work area.
• Avoid all electrical dangers. Pay attention to the risks of
electric shock or arc flash hazards
• Always bear in mind the risk of drowning, electrical accidents
and burn injuries
WARNING: This pump is designed for use with
fresh water and salt water ONLY. Use with any
other hazardous, caustic, or corrosive material
could result in damage to the pump and the
surrounding environment, possible exposure to
hazardous substances and injury.
WARNING: Do not use a pump if it presents
some damage such as burned or broken pres-
sure switch, broken port clips, exposed electric
wire and/or contacts.
WARNING: Explosion hazard.
Do not use motor pump units for pumping
gasoline, solvents, thinners or other
flammable liquids with flash point below
100°F (37.8°C). Doing so may result in
explosion, which could cause personal injury,
death or property damage.
Installation/Mounting
CAUTION:
Not for continuous duty, intermittent duty only.
CAUTION: Installation Notes:
To avoid the risk of fire. Be sure that the area
where pump is installed is isolated from gas,
fuel tanks, electrical wiring looms or flammable
substances. Failure to do so may cause personal
injury, death or property damage.
2
STOP