Precor Experience AMT 800 Assembly Manual

Experience™ Series AMT 800 Adaptive Motion Trainer
Assembly Guide
Assembly Requirements
Precor recommends at least two people for this installation. DO NOT attempt
assembly by yourself.
When assembling the equipment, we recommend you:
• Read the complete instructions before you begin assembly.
• Follow the assembly instructions in order.
• Locate the equipment at least .6 m (23.6 inches) away from walls or furniture on
either side of the equipment, and .6 m (23.6 inches) away from objects behind.
• Assemble the equipment on a solid, flat surface so it remains level and stable.
• DO NOT move equipment without assistance.
Console
support
Left moving
Holder
arm
cover
Support
gasket
Top front
cover
Center front
cover
Left arm
Lower front
cover
Left side
cover
Left support
arm
Center support
frame
Adjustable
foot
Figure 1. AMT
©2024 Precor Incorporated
Right moving
arm
Arm
boot
Right arm
Outer cam
cover
Inner cam
cover
Right side
cover
Right support
arm
Foot plates
Pedestal
Required tools
• #2 Phillips screwdriver • Rubber mallet • 7/16-inch open-end wrench
• Two #1 Phillips screwdrivers • SAE standard socket set
• Torque wrench (including a 3/16-inch hex wrench bit)
Hardware Kit
Name
1 1
Nylon lock nuts (5/16-inch)
2 2
Hex head bolts (5/16-inch x 1-inch)
3 3
Hex head bolts (5/16-inch x 3-1/2-inch)
4 4
Bolt sleeve
5 5
Flat washer (5/16-inch)
6 6
Philips screw (#10 x 1-1/4-inch)
7 7
Flat head hex screw (1/4-inch x 5/8-inch)
8 8
End caps
9 9
Conduit (optional)
10 10
Set screw (3/8-inch x 1-1/4-inch)
Philips screw (#10 x 3/4-inch)
Tooth washer
IMPORTANT Before you fully tighten a fastener, check that its head is flush with the surface of the
equipment. If not, cross-threading may have occurred. DO NOT attempt to rework the assembly
as more damage to the equipment will occur. Contact Precor support.
Assembly Instructions
1. Secure tie rod to arm shaft
The left arm tie rod is wrapped inside the
AMT. The hex head bolt and washer are
attached to the arm shaft.
1. Remove the wood supports used for
shipping and discard the wood and
fasteners.
2. Remove the padding on the tie rod
and remove the hex head bolt and
large washer from the arm shaft.
3. From the user side, shift the left foot
plate slightly to provide some give to
the tie rod.
4. Slightly rotate the tie rod and slide on to the shaft. Secure with the large washer
and hex head bolt (Figure 2).
5. Torque the fastener to 300 in-lb (33.9 N-m).
Qty
Figure 2.
AMT| Assembly Guide | P/N 304438-101F | 2024 11 11 | Page 1 of 4
6
6
6
2
6
14
5
2
1
4
2
2