Analog Devices EVAL-AD5677RSDZ User Manual page 4

UG-1766
EVALUATION BOARD SOFTWARE QUICK START PROCEDURES
INSTALLING THE SOFTWARE
The EVAL-AD5677RSDZ uses the
which allows the evaluation and control of multiple evaluation
systems.
The ACE installer installs the necessary
Microsoft® .NET Framework 4 by default. The
available for download from the EVAL-AD5677RSDZ product
page. This software must be installed before connecting the
board to the USB port of the PC to ensure that the
is recognized and connected to the PC. For full instructions on
how to install and use this software, see the
on the Analog Devices website.
After installation completes, the EVAL-AD5677RSDZ plug-in
appears when the ACE software is opened.
INITIAL SETUP
To set up the evaluation board, take the following steps:
1. Connect the evaluation board to the
connect the USB cable between the
2. Run the ACE application. The EVAL-AD5677RSDZ plug-ins
appear in the attached hardware section of the Start tab.
3. Double-click the board plug-in to open the board view
shown in Figure 2.
4. Double-click the AD5677R
diagram. This view provides a basic representation of the
functionality of the board. The main functions of the board
are labeled in Figure 3.
ACE evaluation software,
SDP-B drivers and the
ACE software is
SDP-B
SDP-B board
ACE software page
SDP-B board. Then,
SDP-B board and the PC.
chip to access the chip block
Figure 2. Board View of the EVAL-AD5677RSDZ
Figure 3. Chip Block Diagram of the
Rev. 0 | Page 4 of 13
EVAL-AD5677RSDZ
AD5677R
User Guide