JVC DR-M100S Instructions Manual page 73

Timer Recording
Timer programming cannot be made.
●
Date and time is not correct.
] Set date and time correctly. (A pg. 20, 69)
●
Timer recording is in progress.
] Timer programming can't be performed while a timer recording
is in progress. Wait until it finishes.
Timer programming recording does not start.
●
Date and time is not correct.
] Set date and time correctly. (A pg. 20, 69)
VIDEO Plus+ Timer Programming cannot be made.
●
Date and time is not correct.
] Set date and time correctly. (A pg. 20, 69)
●
The channel position does not correspond to that in the
receiving area.
] Set the correct channel position for the receiving broadcast.
(A pg. 19, 65)
The VIDEO Plus+ system does not timer record properly.
●
The unit's channel positions have been set incorrectly.
] Refer to AGuide Programme Number SetB (A pg. 65) and re-
perform the procedure.
Automatic Satellite Programme Recording does not start.
●
The satellite receiver is not connected properly to this unit.
] Connect the satellite receiver to the unit's [L-2 IN/DECODER]
connector properly. (A pg. 43)
On the front display panel, AcB appears.
●
Power failure occurred.
] Set date and time correctly. (A pg. 69)
The disc space does not increase when recorded titles are
cleared.
●
The PC's data recorded on a DVD-RAM drive cannot be
cleared on this unit.
] Format the disc. (When the disc is soiled, wipe the disc with a
soft dry cloth before formatting.) (A pg. 10, 70)
APROGRAMME FULLB appears on the TV screen during timer
programming.
●
All 8 programmes have already been timer programmed.
] Clear unnecessary programmes on the unit, then try timer
programming again.
Other Problems
The image of the TV broadcast appears distorted on the TV
screen.
] Press PROGRESSIVE SCAN for 3 or more seconds so that the
Video output indicator (q) lights off on the front display panel.
Whistling or howling is heard from the TV during camcorder
recording.
●
The camcorder's microphone is too close to the TV.
] Position the camcorder so its microphone is away from the TV.
●
The TV's volume is too high.
] Turn the TV's volume down.
When scanning channels, some of them are skipped over.
●
Those channels have been designated to be skipped.
] If you need the skipped channels, restore them using AManual
Channel SetB. (A pg. 67)
Channel settings that were made manually seem to have
changed or disappeared.
●
After the manual settings were made, Auto Channel Set was
performed.
] Do no perform Auto Channel Set after making manual settings,
proceed to perform AClock SetB (A pg. 69).
Malfunction occurs and the unit cannot be power off.
] Reset the unit by disconnecting the AC power plug from the AC
outlet and connect again.
TROUBLESHOOTING
73
EN