Initial Settings; Auto Set Up - JVC DR-M100S Instructions Manual

INITIAL SETTINGS

18
EN

Auto Set Up

Auto Channel Set/Auto Clock Set/Auto Guide
Programme Number Set
After the A button on the unit (or DVD A on the remote
control) is pressed for the first time to turn on the unit, the Auto
Set Up function sets the tuner channels, clock and Guide
Programme numbers automatically.
1
Before starting, make sure of the following:
●
The TV aerial cable should be connected to the unit.
●
The unit's mains power cord should be connected to a mains
outlet.
●
Turn on the TV and select an input mode such as EXT1.
1
Press A on the unit or DVD A on the remote control to turn
on the unit. The AUTO SET/T-V LINK display appears on the TV
screen.
2
Press selection keys to
select AAUTO SETB,
then press ENTER.
●
Auto Channel Set is
performed.
●
When Auto Channel Set
is completed, ASCAN
COMPLETEDB appears
on the TV screen.
DVD A
Selection Keys
(FGDE)
ENTER
INITIAL SET UP
INITIAL SET UP / CHANNEL SET
AUTO SET
T-V LINK
SET UP OK
SELECT WITH [CURSORS]
THEN PRESS [ENTER]
RETURN SELECT
INITIAL SET UP
INITIAL SET UP / CHANNEL SET
AUTO SET
AUTO SET
T-V LINK
PLEASE WAIT...
CANCEL
OK
SET UP
SELECT WITH [CURSORS]
THEN PRESS [ENTER]
SELECT
RETURN
ATTENTION:
AAUTOB blinks on the front display panel; do NOT press any button
on the unit or remote control until the front display panel shows
clock time, APR1B or AcB as illustrated on page 20.
●
When you have connected the unit to a TV offering T-V Link via a
fully-wired 21-pin SCART cable (A pg. 17) and the TV is turned
on, the unit automatically performs the Preset Download
(A pg. 19) even if you select AAUTO SETB for Auto Set Up
function.
ATTENTION:
Once you have performed AAuto Set UpB, even if the unit's
memory backup has expired, all the stored stations and their
Guide Programme numbers remain in the unit's memory and the
unit will not perform AAuto Set UpB again. Perform clock set
manually after turning on the unit. (A pg. 69)
If you have moved to a different area, perform each setting as
required.
●
Tuner setting (A pg. 66)
●
Clock setting (A pg. 69)
If a new station starts broadcasting in your area, perform tuner
setting. (A pg. 66)
NOTES:
●
In areas where no TV station transmits a PDC (Programme
Delivery Control) signal, the unit can perform neither Auto Clock
Set nor Auto Guide Programme Number Set.
If there is a power cut, or if you press A or SET UP while AAuto
●
Set UpB is in progress, AAuto Set UpB will be interrupted. Be sure
to turn off the unit power once and try again from step 1.
●
Auto Clock Set may not function properly depending on the
reception condition.
After AAuto Set UpB is completed, perform AMonitor SetB on
page 22.