JVC DR-M100S Instructions Manual page 68

SUBSIDIARY SETTINGS
68
EN
Set Stations (A)
Set station names that are registered in your unit.
1
Perform steps 1 - 3 of AManual Channel SetB (A pg. 67).
2
Press selection keys to select the channel you want to modify,
then press ENTER twice. The setting screen appears.
3
Press selection keys to select AIDB, then press ENTER for
confirmation.
4
Press selection keys to select the desired ID from the
registered station names ID (A pg. 76), then press ENTER.
●
The confirmation screen appears.
5
Press selection keys to select AOKB, then press ENTER.
6
Press SET UP.
●
Repeat steps 2 - 5 as necessary.
7
Press SET UP or RETURN twice to complete the setting.
Set Stations (B)
Set station names other than the ones registered in your unit.
1
Perform steps 1 - 3 of AManual Channel SetB (A pg. 67).
2
Press selection keys to select the channel you want to modify,
then press ENTER twice. The setting screen appears.
3
Press selection keys to select AIDB, then press ENTER twice
for confirmation.
●
The confirmation screen appears.
4
Press selection keys to move the arrow to the character entry
field.
5
Press selection keys to select the desired characters (A–Z, 0–
9, –, Z, +, & (space)), then press ENTER at the character
entry position.
●
You can enter up to 4 letters.
6
Confirm the arrow is on AOKB, then press ENTER.
7
Press SET UP to return to the Manual Channel Set screen.
● Repeat steps 2 - 7 as necessary.
8
Press SET UP or RETURN twice to complete the setting.
NOTE:
The characters available for the station name (ID) are A–Z, 0–9, –,
Z, +, & (space) (maximum of 4).
Fine-Tuning Channels Already Stored
1
Perform steps 1 - 3 of AManual Channel SetB (A pg. 67).
2
Press selection keys to select the channel you want to fine-
tune, then press ENTER twice. The setting screen appears.
3
Press selection keys to select AFINEB.
4
Press D E until the picture appears in its best quality.
● Repeat steps 2 - 4 as necessary.
5
Press SET UP to return to the Manual Channel Set screen.
6
Press SET UP or RETURN twice to complete the setting.