Remote Control Functions - JVC DR-M100S Instructions Manual

OTHERS
AUTO TIMER OFF / ON
^
8
This is the setting for engaging timer recording standby mode.
OFF
:
Press TIMERj to engage timer recording standby mode.
ON
:
Timer recording standby mode is automatically engaged when
the unit is turned off.
RESUME ON
^ OFF / / DISC RESUME
8
When this function is set to AONB or ADISC RESUMEB, you can use
the resume function.
OFF
:
You cannot use the resume function.
ON
:
The resume function works on the disc loaded on the unit.
DISC RESUME
:
The unit retains a memory of the resume points of the last
30 discs played back, even though they have been ejected.
NOTE:
ADISC RESUMEB setting works on DVD VIDEO, VCD, SVCD and
finalised DVD-R/DVD-RW (Video mode) discs. For other types of
discs, the function under AONB setting will be applied even if
ARESUMEB is set to ADISC RESUMEB.

Remote Control Functions

Remote Control 1/2/3/4 Code Switching
The remote control is capable of controlling four JVC video units
independently. Each of the units can respond to one of the four
codes (1, 2, 3 or 4). The remote control is preset to send code 3
signals because your unit is initially set to respond to code 3
signals. You can easily modify your unit to respond to code 1, 2 or
4 signals.
A
1-4
●
Keep pressing SET UP down during step 1.
1
Press the number key A1B for 1, A2B for 2, A3B for 3 or A4B for 4 to
change the remote control code, then press ENTER.
2
Press A on the unit to turn off the unit.
3
Press I on the unit for over 5 seconds while the unit is turned
off. The code currently set appears on the front display panel.
4
Press o on the remote control to change the unit's code. The
code currently set on the remote control blinks on the front
display panel for approximately 5 seconds, and is applied to the
unit.
SUBSIDIARY SETTINGS
EN
RAM/RW
I
ENTER
o
SET UP
63