Siqura FD1104v2FR Quick Start Manual

FD1104v2FR
4MP Face Recognition Network Camera
Quick Start Guide
Unpack
Mounting Plate
FD1104FR Camera Unit
Security Torx
Note 1: Subject to modification. Actual product and accessories may differ in appearance.
Connectors
Copyright © TKH Security B.V. 2023 | Version 2 (20230209) | FD1104v2FR-QS-EN
Find additional manuals, the datasheet,
the EU Declaration of Conformity, and
the latest firmware for this product at:
Siqura.com/downloads/software
Caution installation shall be performed by qualified personnel
only. Installation shall be in accordance with local procedures.
The camera contains batteries.
Battery replacement shall not be applied in view of the risk of
Quick Start Guide
explosion. Dispose of used batteries according to the
instructions.
For "PoE" input connection, use only with UL listed I.T.E. with
"PoE" output. Description for the "PoE" is intended to be
M5 Screws(8x) &
connected to not exposed (outside plant) networks or
Plastic Screw
equivalent statement in installation instructions.
Anchors (8x)
Reset button and Micro SD card slot
To restore camera to factory
defaults, power up with Reset
button pressed for at least 10s
Note:
It is not recommended to continuously (24/7) record with the micro SD card, as
the camera may not support long-term continous data read/write. Contact the
manufacturer of the micro SD card for information regarding the reliability and
the life expectancy.
Installation Notices
Micro SD card slot
Connectors
Figure 2 Camera Connectors
Accessing the camera - DHCP Server
DHCP
Network Switch
IP = 10.x.y.z
IP = 10.x.y.z
DHCP Server
IP = 10.x.y.z