PICOTE Xpress Coating System Operation & Installation Manual page 5

ENVIRONMENT, TRANSPORT, STORAGE & DISPOSAL
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE
ENVIRONMENTAL:
•
Operational Ambient Temperature Range: 10°C to 50°C (50°F to 122°F), frost and condensation free
•
Storage Ambient Temperature Range: 0°C to 50°C (32°F to 122°F), frost and condensation free
•
Maximum Altitude: 2000m or 6500 ft. Derate above 1000m or 3280 ft: 1% / 100m or 328 feet
•
Maximum Humidity: 95% non-condensing
•
NOTE: When using the Xpress Coating System outside, it should be protected from the elements (rain
and snow) with a suitable tent or shelter.
TRANSPORT:
Xpress Coating Pump should be transported in a vehicle or trailer secured with ratchet straps to prevent any
sudden movements or accidents caused by hard braking or accident. If transported in a laid down/horizontal
position, make sure the resin reservoir lids and lid plugs are securely in place to avoid spillage.
The Xpress Hose Reel should be transported in a vehicle or trailer in a laid down position secured with
ratchet straps to prevent any sudden movements or accidents caused by hard braking or accident.
STORAGE:
It is recommended that the Xpress Coating System be stored indoors to protect them from rain and sunlight,
and also in a constant ambient temperature.
If the Xpress Coating System has been stored in an environment colder than +10°C or 50°F, it should be
stood at room temperature for 24 hours before use.
If the Xpress Coating System has been stored for a long period of time (over 1 months), it should be checked
and tested according to the maintenance programme before use.
Charge the Xpress Pump battery to around 80% capacity before storing for long periods.
NEVER leave the unit unattended while it is charging.
DISPOSAL:
Xpress Coating Pump actuators, Hose Reel motor, control box, electric wires and power supply can be
disposed in Europe at Waste Electrical and Electronic Equipment (WEEE) collection points.
The Xpress Coating Pump and Hose Reel frame can be recycled in metal waste collection points. Delivery
and Supply Hoses, resin reservoirs and cylinders are contaminated with the resin components and
should be disposed of as per local, regional, and national regulations.
Dispose of unused Resin by mixing the product in a well ventilated location using a non-flammable
container. Mixed product will generate heat while hardening. Follow the SDS sheets which can be
found on the Picote Institute (picoteinstitute.com) or via the QR code on the resin containers.
Recycle Li-ion batteries according to regulations.
For ALL Disposals: Always follow local, regional, and national waste handling rules and regulations.
Picote Solutions Oy Ltd
This section contains important safety information.
Failure to comply could result in serious injury or death.
Do not dispose of in fire! Do not puncture!
5 www.picoteinstitute.com