PICOTE Xpress Coating System Operation & Installation Manual page 4

GENERAL MACHINE SAFETY INFORMATION
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE
1. Resin SDS Sheets, please scan the QR code from the resin bucket(s) or download from the Picote Institute
(picoteinstitute.com)
2. Always wear eye and ear protection as well as chemical, heat and cut-resistant gloves.
Other personal protective equipment, such as dust mask and protective clothing should be worn when necessary.
3. Always ensure that the machine is fully turned off and unplugged before inspection, maintenance, or installing any
accessories to the machine. Always follow the instructions in the manufacturer's manual.
4. Before each use inspect machine carefully for any potential damage.
immediately.
5. Ensure the pipe has been opened and ventilated to prevent any gases accumulating.
6. Dust produced when working can be dangerous to your health, inflammable or explosive. Make sure that the job
location is well ventilated before grinding or drilling. Always use a vacuum extraction system in the pipe to remove
dust. The operator must wear a dust mask when using dry grinding to clean pipes.
7. If the working environment is extremely hot and humid, or badly polluted by conductive dust, use a GFCI-enabled
power outlet to increase operator safety.
8. Ensure that the ventilation openings are kept clear when working in dusty conditions to avoid damaging internal
parts. If it should become necessary to clear dust, first unplug the machine.
9. When in use, it is very important that the machine is stable and on an even surface at all times.
10. Never leave the machine running
11. Always hold the Miller shaft when operating the machine.
12. Never touch moving or rotating
13. Do not use on any pipes containing asbestos fibres.
Xpress Coating System has been pre-set by the Manufacturer
Picote Solutions accepts no liability for failures or accidents caused by tampering with or changing of the
manufacturer settings. The control box has been pre-programmed and requires no additional
adjustments.
Opening the control box or changing the factory settings may cause damage and will void the
manufacturer liability of any damage!
Picote Solutions Oy Ltd
This section contains important safety information.
Failure to comply could result in serious injury or death.
unattended.
parts.
4
Change or replace damaged parts
www.picoteinstitute.com