Table of Contents
Advertisement
To remove the outer rails from the rack, press the blue plastic button on each outer rail.
Four-post L-bracket rail installation
Use these installation instructions for racks with threaded holes, 9.5 mm (.354 in) square holes, or 7.1 mm (.279) round holes.
Complete the switch installation in the following order:
1. Attach the L-brackets to the front of the switch.
2. Attach the inner rails to the switch.
3. Attach the outer rails to the rear of the four-post rack.
4. Slide the switch into the rack.
5. Secure the L-brackets to the front of the four-post rack.
NOTE:
You need a user-supplied Phillips screwdriver to complete this installation.
22
Z9432F-ON switch installation
Advertisement
Table of Contents
