•
SAS LED cable to the PERC_LED connector
•
SAS/SATA backplane cable to BP_12C connector
•
Intrusion switch cable to the INTRUSION connector
12 Close the system. See "Closing the System" on page 70.
13 Place the system upright and on its feet on a flat, stable surface.
14 Install the front-drive bezel. See "Installing the Front Drive Bezel" on
page 66.
15 Reattach any peripherals, then connect the system to the electrical outlet.
16 Turn on the system and attached peripherals.
Installing System Components
157