Dell PowerEdge DR715 Hardware Owner's Manual page 135

7 Wait 30 seconds for the heat sink to loosen from the processor.
8 Gently lift the heat sink off of the processor and set the heat sink aside.
NOTE:
adhesive on the bottom of the heat sink.
NOTICE:
The processor is held in its socket under strong pressure. Be aware that
the release lever can spring up suddenly if not firmly grasped.
9 Position your thumb firmly over the socket-release lever and release the
lever from the locked position. Rotate the lever 90 degrees upward until
the processor is released from the socket. See Figure 3-35.
10 Rotate the processor shield upward and out of the way.
Figure 3-35. Installing and Removing a Processor
1
7
1 notch in processor (2)
3 ZIF socket shield
5 ZIF socket
7 socket key (2)
Lay the heat sink on its side to avoid contaminating the thermal
2
6
2 processor
4 socket-release lever
6 processor shield
Installing System Components
3
4
5
135