Super Io Configuration; Usb Configuration; Pci Configuration - Dell PowerEdge C1100 Hardware Owner's Manual

Super IO Configuration

Option
Serial Port1 Address
(3F8/IRQ4 default)
Serial Port2 Address
(3F8/IRQ4 default)

USB Configuration

Option
USB Devices Enabled
Legacy USB Support
(Auto default)
USB 2.0 Controller
USB Mass Storage Reset
Delay (20 Sec default)
Device#
Emulation Type (Auto
default)

PCI Configuration

Option
NIC1 KAWELA
(Enable with PXE
default)
NIC2 KAWELA
(Enable with PXE
default)
Description
Assigns the I/O address and IRQ for the first onboard
serial port.
Assigns the I/O address and IRQ for the second onboard
serial port.
Description
Displays USB devices currently detected.
Enables support for legacy USB devices. Select Auto to
disable legacy support if no USB devices are connected.
Configures the USB 2.0 controller in HiSpeed
(480 Mbps) or FullSpeed (12 Mbps).
Displays the number of seconds that the POST waits for
the USB mass storage device after the start unit
command is issued.
USB device model name.
If the type is set to Auto, USB devices which are
less than 530 MB are emulated as floppies and the
others are emulated as hard drives. Forced FDD option
can be used to force a formatted hard drive to boot
as FDD (e.g. ZIP drive).
Description
Enables or disables onboard 82576 NIC1 PXE
option ROM.
Enables or disables onboard 82576 NIC2 PXE
option ROM.
Using the System Setup Program
39