Removing Memory Modules - Dell PowerEdge C1100 Hardware Owner's Manual

Removing Memory Modules

WARNING:
has been powered down. Allow time for the memory modules to cool before
handling them. Handle the memory modules by the card edges and avoid touching
the components on the memory module.
CAUTION:
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Open the system. See "Opening the System" on page 53.
3 Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 54.
4 Locate the memory module sockets.
5 Press down and out on the ejectors on each end of the socket until the
memory module pops out of the socket. See Figure 3-9.
Handle each memory module only on either card edge, making sure not to
touch the middle of the memory module.
CAUTION:
not to touch the middle of the memory module.
6 Lift out the memory module.
7 Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 55.
8 Close the system. See "Closing the System" on page 54.
9 Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.
64
Installing System Components
The memory modules are hot to touch for some time after the system
Many repairs may only be done by a certified service technician.
Handle each memory module only on either card edge, making sure