Ozito PCS-305A Troubleshooting

PCS-305A
305mm (12") 25.4cc Petrol Chainsaw
My Chainsaw won't start!
1
Check On/Off switch.
Was the On/Off switch set to the
On ("I") position? The chainsaw
will only start if the switch is in the
On ("I") position.
4
Was the choke engaged?
The choke control needs to
be fully raised for start up.
The choke control will then
retract on its own when the
throttle trigger is pressed.
7
contact with the lead. Inspect
necessary.
Have any questions, call Ozito on (Aus) 1800 069 486 (NZ) 0508 069 486
2
Is the fuel mix correct?
Use fresh unleaded fuel and
2 stroke oil in 40:1 mix.
(Following prolonged storage,
you must change with fresh
fuel & oil to prevent stalling).
5
Is the priming bulb full?
The priming bulb must be full
to start the chainsaw. To do so
press the priming bulb 6 times
or until the bulb is full of fuel.
Now start the chainsaw.
8
Spark plug gap 0.7mm?
Periodically inspect and
clean gap or replace when
necessary.
3
FUEL MIX
BAR OIL
Is the fuel in the correct
tank? Have you put fuel mix
into the fuel tank and not the
bar oil tank? If so you will need
6
Have you pulled up to 15
times? Repeat at least 15
times minimum for the engine
to start. When started allow
10 seconds warm up before
use.
9
Are you having trouble
tuning your chainsaw? The
carburettor is factory set and
should not require adjustment.
Contact Ozito Customer Service
for advice and instructions.