ADF Web HD67664-A1 User Manual page 19

Industrial Electronic Devices
Note:
When you install a new version of the software, if it is the first time it is better you do the update of the Firmware in the HD67664
device.
Note:
When you receive the device, for the first time, you also have to update the Firmware in
the HD67664 device.
Warning:
If Fig. 6 appears when you try to do the Update try these points before seeking
assistance:
Try to repeat the operations for the updating;
Try with another PC;
Try to restart the PC;
Check the LAN settings;
If you are using the program inside a Virtual Machine, try to use in the main
Operating System;
If you are using Windows Seven, Vista and 8, 10 or 11 make sure that you have the
administrator privileges;
In case you have to program more than one device, you have to cancel the ARP table
every time you connect a new device on Ethernet. For do this you have to launch the
"Command Prompt" and write the command "arp -d". Pay attention that with
Windows Vista, Seven, 8, 10 or 11 you have to launch the "Command Prompt" with
Administrator Rights;
Pay attention at Firewall lock.
In the case of HD67664 you have to use the software "SW67664": www.adfweb.com\download\filefold\SW67664.zip.
ADFweb.com S.r.l.
User Manual EtherNet/IP / Modbus TCP Master
Document code: MN67664_ENG Revision 1.001
Figure 8: "Protection" window
Page 19 of 28